Description

The Aimpoint® ACRO® P2 is rapidly becoming the ‘go-to’ red dot optic forprofessional working pistols. The rugged closed-emitter design andaerospace grade aluminum case has proven to take a beating thatsidelines competitors. That said, the front lens is front and center fortaking potential damaging impact. The good news is, it is easilyreplaced at minimal charge. The bad news, it has to go back to thefactory for that service. Avoid the hassle and protect your expensivered dot with the Tango Down P2 Lens Guard.

Precision CNC machined aerospace grade aluminum frame, with TypeIII hard coat anodize, easily attaches in seconds to your P2 withprovided stainless-steel set screws. The Lens Guard also makes agreat ‘slide racker’, without leaving hand prints on your P2 front lens.

The P2 Lens Guard works best on OEM ‘Optic Ready’ systemsutilizing mount plates. Some aftermarket ‘Direct Cut’ slides may allowP2 optic to sit deep in the slide, with no clearance in front of P2.That will prevent from the P2 Lens Guard from seating properly.

Note: The P2 Lens Guard doesNOTfit the ACRO® P1.

Features:

• Easily attaches with supplied stainless- steel fasteners and wrench
• Type III Hard Coat Anodize
• 6061 T6 CNC machined frame provides maximum P2 front lens protection

Colors available:Black Only

Important Note: P2 Lens Guard fasteners are 2-56 in size. This means VERY SMALL!Tango Down recommends just finger tight only on these screws. In extreme applications,use only the weakest available grade of thread locker.